Skip to content
    OBD Tuning
    Send to us
    Send to us
    Home
    Fault Codes
    VOLVO
    ECM-P064611
    VOLVO

    ECM-P064611 - A/C Clutch Relay Control Circuit Low. General Electrical Failures. Circuit short to ground

    System

    Engine Control Module (ECM)

    Volvo models this fault code applies to

    Applies to the following models:

    9 models

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)

    Show models by year and engine (32)
    • Volvo S60 (2011–)2011All engines except: B6304T4, D4162T, D5204T2, D5244T10
    • Volvo S60 (2011–)2012Engine B4164T, B4164T2, B4164T3, B4204T7, B5254T5 only
    • Volvo S60 (2011–)2013–2014Engine B4164T, B4164T2, B4164T3, B4204T7 only
    • Volvo S60 (2011–)2015Engine B4164T, B4164T2, B4164T3 only
    • Volvo S80 (2007–)2007All engines except: B6324S, B8444S
    • Volvo S80 (2007–)2008Engine B5254T6, D5244T4, D5244T5 only
    • Volvo S80 (2007–)2009Engine B5254T6, B5254T8, D5244T4, D5244T5 only
    • Volvo S80 (2007–)2010Engine B4204T6, B5254T10, B5254T11, B5254T8, D4164T only
    • Volvo S80 (2007–)2011Engine B4164T, B4204T6, B4204T7, B5254T10, B5254T11, B5254T8, D4164T only
    • Volvo S80 (2007–)2012Engine B4164T, B4164T2, B4204T6, B4204T7, B5254T10 only
    • Volvo S80 (2007–)2013–2014Engine B4164T, B4164T2, B4204T6, B4204T7 only
    • Volvo S80 (2007–)2015Engine B4164T only
    • Volvo V40 (2013–)2013Engine B4164T, B4164T3 only
    • Volvo V40 (2013–)2014–2015Engine B4164T, B4164T3, B4164T4 only
    • Volvo V40 Cross Country (2013–)2013–2015Engine B4164T only
    • Volvo V60 (2011–)2011Engine B4164T, B4164T3, B4204T6, B4204T7 only
    • Volvo V60 (2011–)2012–2014Engine B4164T, B4164T2, B4164T3, B4204T7 only
    • Volvo V60 (2011–)2015Engine B4164T, B4164T2, B4164T3 only
    • Volvo V70 (2008–)2008Engine B5254T6, D5244T4, D5244T5 only
    • Volvo V70 (2008–)2009Engine B5254T6, B5254T8, D5244T4, D5244T5 only
    • Volvo V70 (2008–)2010Engine B4204T6, B5254T10, B5254T11, D4164T only
    • Volvo V70 (2008–)2011Engine B4164T, B4204T6, B4204T7, B5254T10, B5254T11, D4164T only
    • Volvo V70 (2008–)2012Engine B4164T, B4164T2, B4204T7, B5254T10 only
    • Volvo V70 (2008–)2013–2014Engine B4164T, B4164T2, B4204T7 only
    • Volvo V70 (2008–)2015Engine B4164T, B4164T2 only
    • Volvo XC60 (2009–)2009All engines except: B6304T2
    • Volvo XC60 (2009–)2010Engine B4204T6 only
    • Volvo XC60 (2009–)2011–2012Engine B4204T6, B4204T7 only
    • Volvo XC60 (2009–)2013–2015Engine B4204T7 only
    • Volvo XC70 (2008–)2008All engines except: B6324S
    • Volvo XC70 (2008–)2009Engine D5244T4, D5244T5 only
    • Volvo XC90 (2003–)2013–2014Engine D5244T18, D5244T5 only

    What does this fault code mean?

    The fault concerns a signal to the A/C coupling relay that is too low, which may be caused by a short to ground. The engine control module (ECM) drives the A/C compressor's stroke volume through a control valve and compares the valve signal with expected values. At high torque output the module can switch the A/C function off.

    Possible causes

    • Signal wire shorted to ground
    • Signal wire shorted to supply voltage, or a faulty A/C relay; see fault code ECM-P064712
    • Poor contact or oxidation at the connectors, or an open signal wire; see fault code ECM-P064513
    • Poor contact or oxidation at the terminals, an open supply wire, or a faulty control valve; see fault code ECM-P064519
    • Open circuit or short to ground in the signal wire or the supply wire

    What you can do

    1. 1Check that the fuses are intact and that the connectors are secure and free from corrosion
    2. 2With the ignition off, use a multimeter to check that the signal cable to the control valve is not shorted to ground and has no open circuit
    3. 3If you have diagnostic equipment, activate the control valve with the tool and check that the A/C compressor responds
    4. 4If the wiring is intact but the fault remains, have a workshop check the A/C system relays and the control valve

    Symptoms you may notice4

    • The A/C system does not operate
    • Cooling from the A/C is too weak or slow in the rear or front section
    • Uneven temperature in the cabin
    • The heater does not work or does not get warm enough

    What the fault can affect1

    • The A/C system is switched off

    General guidance for car owners. Diagnosis on the car can point to a different cause.

    OBD Tuning

    Sweden's leading expert center for automotive electronics. We offer professional ECU tuning, control unit repair and diagnostics with 12-month warranty.

    Services

    • Engine Tuning
    • ECU Repair
    • Module Cloning
    • Instrument Cluster
    • SRS / Airbag
    • Immobilizer

    Database & Diagnostics

    • ECU Database
    • DTC Fault Code Catalog
    • Diagnostic Guides & Live Data
    • AI Fault Code Analyzer
    • News

    ECU Manufacturers

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Company

    • About us
    • Contact
    • Workshop Partners
    • Shipping Guide
    • Warranty
    • FAQ
    • Terms & Conditions
    • Privacy Policy
    • Site Map

    • Engine Tuning
    • ECU Repair
    • Module Cloning
    • Instrument Cluster
    • SRS / Airbag
    • Immobilizer

    • ECU Database
    • DTC Fault Code Catalog
    • Diagnostic Guides & Live Data
    • AI Fault Code Analyzer
    • News

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • About us
    • Contact
    • Workshop Partners
    • Shipping Guide
    • Warranty
    • FAQ
    • Terms & Conditions
    • Privacy Policy
    • Site Map

    Visit us

    Gjuterigatan 29, Karlstad

    Call us

    054-830 480

    Email us

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. All rights reserved.