VOLVO
ECM-P06DC00 - Engine Oil Pressure Control Circuit High. General Failure Information. No sub type information
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
8 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Show models by year and engine (8)
- Volvo S60 (2011–)2014–2015Engine B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5 only
- Volvo S80 (2007–)2014–2015Engine B4204T11, B4204T12, B4204T15, D4204T5 only
- Volvo V40 (2013–)2015Engine B4204T11, D4204T14 only
- Volvo V40 Cross Country (2013–)2015Engine B4204T11, D4204T14 only
- Volvo V60 (2011–)2014–2015Engine B4204T11, B4204T12, B4204T15, B4204T9, D4204T5 only
- Volvo V70 (2008–)2014–2015Engine B4204T11, D4204T5 only
- Volvo XC60 (2009–)2014–2015Engine B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5 only
- Volvo XC70 (2008–)2014–2015Engine B4204T11, D4204T5 only
What does this fault code mean?
The control module monitors the oil pump actuator electrically and uses it to control engine oil pressure. The code indicates a signal that is too high in the circuit. The fault may come from a signal wire short-circuited to voltage, or from a defective or worn oil pump.
Possible causes
- Signal wire short-circuited to supply voltage
- The oil pump is defective or worn
What you can do
- 1Read and clear the fault code, and test-drive to see whether it returns
- 2Check that the connector at the oil pump actuator is secure and clean
- 3Look at the wire to the oil pump actuator for chafing and pinch damage, especially where it may have touched positive
- 4Use a multimeter to check that the signal wire has no contact with voltage, with the connectors disconnected
- 5If the fault remains, have a workshop check the oil pump and its actuator
Symptoms you may notice1
- No noticeable symptoms for the driver
General guidance for car owners. Diagnosis on the car can point to a different cause.