VOLVO
ECM-P129613 - Injector Multiple Faults - Bank 2. General Electrical Failures. Circuit open
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
5 modelsS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Show models by year and engine (6)
- Volvo S80 (2007–)2007–2009Engine D5244T4, D5244T5 only
- Volvo V70 (2008–)2008–2009Engine D5244T4, D5244T5 only
- Volvo XC60 (2009–)2009All engines except: B6304T2
- Volvo XC70 (2008–)2008All engines except: B6324S
- Volvo XC70 (2008–)2009Engine D5244T4, D5244T5 only
- Volvo XC90 (2003–)2013–2014Engine D5244T18, D5244T5 only
What does this fault code mean?
The code is set when the signal to the injectors in bank 2 is absent. This can be caused by an open circuit in the wiring to the injectors, by damaged injectors, or by an internal fault in the control module.
Possible causes
- Open circuit in the wiring to the injectors
- Damaged injectors
- Internal fault inside the ECM
What you can do
- 1Check that the fuses are intact. The locations are in the owner's manual or on the fuse box cover.
- 2Check the connectors to the injectors in bank 2 so they are secure and clean.
- 3Look for broken or pinched wires to the injectors in bank 2.
- 4With the ignition off, use a multimeter to check that the wire to the injectors in bank 2 is not broken.
- 5If the fault comes back, have a workshop check the injectors in bank 2 and the control module with diagnostic equipment.
Symptoms you may notice1
- The engine does not start, and when the fault shows is unclear
What the fault can affect1
- Injection stops
General guidance for car owners. Diagnosis on the car can point to a different cause.