VOLVO
ECM-P200900 - Intake Manifold Runner Control Circuit Low (Bank 1). General Failure Information. No sub type information
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
8 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Show models by year and engine (8)
- Volvo S60 (2011–)2014–2015Engine D4204T5 only
- Volvo S80 (2007–)2014–2015Engine D4204T5 only
- Volvo V40 (2013–)2015Engine D4204T14 only
- Volvo V40 Cross Country (2013–)2015Engine D4204T14 only
- Volvo V60 (2011–)2014–2015Engine D4204T5 only
- Volvo V70 (2008–)2014–2015Engine D4204T5 only
- Volvo XC60 (2009–)2014–2015Engine D4204T5 only
- Volvo XC70 (2008–)2014–2015Engine D4204T5 only
What does this fault code mean?
The engine control module (ECM) checks how the swirl damper motor works. The code is set when the signal from the learned closed end position of the swirl damper motor is incorrect. The test is only run after a drive, once its conditions are met.
Possible causes
- Defective swirl damper motor
- Swirl damper jams or has stuck
- Damaged swirl damper arm
- Damaged swirl damper end stop
What you can do
- 1Check that the swirl damper is not jammed or stuck in its end position
- 2Check that the swirl damper arm and end stop are not damaged
- 3If you have a diagnostic tool: read the status of the code after a drive to see whether it is active
- 4If the fault remains, have a workshop check the swirl damper motor and carry out a new learning of the end position
Symptoms you may notice1
- No noticeable symptoms for the driver
General guidance for car owners. Diagnosis on the car can point to a different cause.