VOLVO
IEM-U1A4B63 - Control Module Processor B. Algorithm Based Failures. Circuit / component protection time-out
System
Unknown System / Manufacturer Specific
Volvo models this fault code applies to
Applies to the following models:
1 modelV60 (2011–)
Show models by year and engine (2)
What does this fault code mean?
The electric rear axle drive module (IEM) monitors its internal components. The code is stored when the microprocessor has an internal fault. The fault is only checked once the vehicle is in driving position, meaning the car has been cranked and either the electric or the combustion engine has started.
Possible causes
- Software error in the electric rear axle drive module (IEM)
- Internal fault inside the ISC voltage converter
What you can do
- 1Read out, clear the code, start the car and road test to see whether it returns
- 2Have a workshop check whether new software is available for the control module and install it if needed
- 3If the code returns after the software update, have a workshop check the electric rear axle and the voltage conversion unit ISC
- 4Do not work on the electric rear axle or its high voltage system yourself; have a workshop carry out those checks
Symptoms you may notice4
- Warning symbol and text message in the display
- PURE drive mode disengages by itself or is not available
- AWD drive mode disengages by itself or is not available
- HYBRID drive mode runs with the combustion engine active all the time or too often
What the fault can affect2
- Electric propulsion is not possible
- Brake energy recovery from the electric rear axle ERAD is not possible
General guidance for car owners. Diagnosis on the car can point to a different cause.