VOLVO
PBM-U210054 - Control Module Not Configured. System Programming Failures. Missing calibration
System
Powertrain (Engine & Gearbox)
Volvo models this fault code applies to
Applies to the following models:
9 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
What does this fault code mean?
The electronic parking brake module (PBM) has a built-in inclination sensor used to decide how hard to apply the brake on a slope. The code means the inclination sensor has not been calibrated, the installation check has not been done, or the module is still in service mode.
Possible causes
- The inclination sensor has not been calibrated, for example after replacing the module
- The installation check has not been carried out after fitting
- Service mode is still active, for example after replacing the rear brake pads
What you can do
- 1Find out whether the rear brakes or the parking brake module have recently been serviced or replaced
- 2Have a workshop with diagnostic equipment exit service mode, calibrate the inclination sensor and run the installation check
- 3Afterwards, check that the parking brake applies and releases correctly
- 4Do not rely on the parking brake on a slope until the fault is fixed – leave the car in gear or in P
Symptoms you may notice3
- Parking brake warning lamp on
- Yellow warning symbol and message in the display
- The parking brake has reduced function
General guidance for car owners. Diagnosis on the car can point to a different cause.