VOLVO
PDM-B11B915 - Passenger Blind Spot Warning Indicator Supply. General Electrical Failures. Circuit short to battery or open
System
Passenger Door Module (PDM)
Volvo models this fault code applies to
Applies to the following models:
4 modelsS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Show models by year and engine (4)
What does this fault code mean?
The passenger door module (PDM) supplies the camera on the passenger side. The control module has flagged a signal from the output that is too high, and the fault is stored when the supply wire is short-circuited to supply voltage or has a break. The LED then does not light, and a message may appear in the information display.
Possible causes
- Power supply cable to the camera short-circuited to supply voltage
- Break in the power supply cable
What you can do
- 1Check that the relevant fuses are intact
- 2Drive the car and note whether the passenger-side blind spot warning appears
- 3Use a multimeter to check that the supply wire to the passenger-side camera has no break and no contact with supply voltage
- 4Look for damage and chafing in the wiring to the passenger door and in the passenger-side external mirror
- 5Repair the wire or connector where you find a fault; if none is found, have a workshop check the camera
Symptoms you may notice2
- LED does not light
- A message appears in the information display
General guidance for car owners. Diagnosis on the car can point to a different cause.