VOLVO
SAS-B124C71 - Turn Indicator Stalk Switch Pack. Mechanical Failures. Actuator stuck
System
Steering Angle Sensor (SAS)
Volvo models this fault code applies to
Applies to the following models:
4 modelsC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Show models by year and engine (8)
- Volvo C30 (2007–2013)2011Engine D4162T, D4164T, D5204T, D5204T5 only
- Volvo C30 (2007–2013)2012–2013Engine D4162T, D5204T, D5204T5 only
- Volvo C70 (2006–2013)2011Engine D5204T, D5204T5 only
- Volvo C70 (2006–2013)2012–2013All engines except: B5254T7
- Volvo S40 (2004–2013)2011Engine D4162T, D4164T, D5204T, D5204T5 only
- Volvo S40 (2004–2013)2012Engine D4162T, D5204T, D5204T5 only
- Volvo V50 (2004–2013)2011Engine D4162T, D4164T, D5204T, D5204T5 only
- Volvo V50 (2004–2013)2012Engine D4162T, D5204T, D5204T5 only
What does this fault code mean?
One or more buttons on the left-hand control stalk have been held down for too long, or the headlamp flash has been on for too long, and the fault is set. The cause is a button that has stuck in the activated position.
Possible causes
- A button on the left-hand stalk stuck in the activated position
What you can do
- 1Check that the fuses are intact
- 2Try the turn signal, high beam and other controls on the left stalk one at a time to see which function does not work
- 3Read and note the code, clear it and road test to see whether it returns
- 4With diagnostic equipment, follow the button status in live data while pressing and releasing the buttons, and see whether any stays pressed
- 5The steering wheel angle sensor is part of the car's safety systems, so have a workshop repair the fault promptly if it remains
Symptoms you may notice5
- Turn signal stalk and other stalk controls do not work
- Parking heater does not operate
- Trip computer reset function does not work
- Text messages on the instrument panel cannot be erased
- High beam does not work
General guidance for car owners. Diagnosis on the car can point to a different cause.