Skip to content
    OBD Tuning
    Send to us
    Send to us
    Home
    Fault Codes
    VOLVO
    SODR-U014000
    VOLVO

    SODR-U014000 - Lost Communication With Central electronic module. General Failure Information. No sub type information

    System

    Side Obstacle Detection Right (SODR)

    Volvo models this fault code applies to

    Applies to the following models:

    6 models

    S60 (2011–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), XC60 (2009–)

    Show models by year and engine (6)
    • Volvo S60 (2011–)2014–2015
    • Volvo V40 (2013–)2013–2015
    • Volvo V40 Cross Country (2013–)2013–2015
    • Volvo V60 (2011–)2014–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo XC60 (2009–)2014–2015

    What does this fault code mean?

    The right side obstacle detection control module (SODR) communicates continuously with the central electronic module (CEM). The code is set when communication between them has been interrupted or is missing. The fault may lie in the wiring or in how the control modules are programmed.

    Possible causes

    • Fault in the central electronic module (CEM) or in the communication to it
    • Open circuit in one or both CAN wires along part of the network
    • Short circuit between the CAN wires, or between a CAN wire and ground or voltage
    • Incorrect signal configuration in the control module that set the code, for example after a replacement where no new software was loaded

    What you can do

    1. 1Read the fault codes in the car; if several control modules hold codes for missing communication, start with the CEM
    2. 2Check that the fuses are intact and that the CEM has a power feed and ground connection
    3. 3Use a multimeter to check that the CAN wires have no open circuit and no short to ground or voltage; disconnect the battery negative lead first
    4. 4Gently wiggle connectors and wires while you measure and see whether the reading changes
    5. 5Clear the fault codes, start the car and read the fault codes again to see whether the fault returns
    6. 6If the code is only stored in the SODR, a workshop needs to reprogram it with the latest software

    Symptoms you may notice3

    • Blind spot warning (BLIS) stops working
    • Cross traffic alert (CTA) does not work
    • Yellow warning symbol and message in the display

    General guidance for car owners. Diagnosis on the car can point to a different cause.

    OBD Tuning

    Sweden's leading expert center for automotive electronics. We offer professional ECU tuning, control unit repair and diagnostics with 12-month warranty.

    Services

    • Engine Tuning
    • ECU Repair
    • Module Cloning
    • Instrument Cluster
    • SRS / Airbag
    • Immobilizer

    Database & Diagnostics

    • ECU Database
    • DTC Fault Code Catalog
    • Diagnostic Guides & Live Data
    • AI Fault Code Analyzer
    • News

    ECU Manufacturers

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Company

    • About us
    • Contact
    • Workshop Partners
    • Shipping Guide
    • Warranty
    • FAQ
    • Terms & Conditions
    • Privacy Policy
    • Site Map

    • Engine Tuning
    • ECU Repair
    • Module Cloning
    • Instrument Cluster
    • SRS / Airbag
    • Immobilizer

    • ECU Database
    • DTC Fault Code Catalog
    • Diagnostic Guides & Live Data
    • AI Fault Code Analyzer
    • News

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • About us
    • Contact
    • Workshop Partners
    • Shipping Guide
    • Warranty
    • FAQ
    • Terms & Conditions
    • Privacy Policy
    • Site Map

    Visit us

    Gjuterigatan 29, Karlstad

    Call us

    054-830 480

    Email us

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. All rights reserved.