VOLVO
TCM-0419 - Position sensor shift fork 4. Signal to low
System
Transmission Control Module (TCM)
Volvo models this fault code applies to
Applies to the following models:
4 modelsC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Show models by year and engine (10)
- Volvo C30 (2007–2013)2008Engine D4204T only · Transmission MPS6 only
- Volvo C30 (2007–2013)2009–2010Engine B4204S3, D4204T only · Transmission MPS6 only
- Volvo C30 (2007–2013)2011–2013Engine B4204S3 only · Transmission MPS6 only
- Volvo C70 (2006–2013)2009–2010Engine D4204T only · Transmission MPS6 only
- Volvo S40 (2004–2013)2008Engine D4204T only · Transmission MPS6 only
- Volvo S40 (2004–2013)2009–2010Engine B4204S3, D4204T only · Transmission MPS6 only
- Volvo S40 (2004–2013)2011–2012Engine B4204S3 only · Transmission MPS6 only
- Volvo V50 (2004–2013)2008Engine D4204T only · Transmission MPS6 only
- Volvo V50 (2004–2013)2009–2010Engine B4204S3, D4204T only · Transmission MPS6 only
- Volvo V50 (2004–2013)2011–2012Engine B4204S3 only · Transmission MPS6 only
What does this fault code mean?
The transmission control module (TCM) receives too low a signal from the position sensor for shift fork 4. The signal shows the fork's position, and when the value is too low the control module cannot read the position correctly. The cause can be in the cable, the sensor or the control module.
Possible causes
- Cable short-circuited to ground
- Damaged position sensor
- Damaged transmission control module (TCM)
What you can do
- 1Have a workshop with diagnostic equipment check the voltage supply to the position sensors; if it is outside the normal range, the fault is inside the control module
- 2Use a multimeter to check that the cable to the position sensor for shift fork 4 has no contact with ground (the car body)
- 3If you have diagnostic equipment, look at the position value for shift fork 4 in live data and see whether it changes when the gears are engaged
- 4If a value is outside or at the limit, a workshop should replace the mechatronic unit; if readings are within limits, the fault has probably been sporadic
- 5If the fault is inside the control module, it must be replaced, and a new module is delivered without software and must be programmed by a workshop
Symptoms you may notice5
- Check engine light comes on or behaves abnormally
- Message with yellow warning symbol in the display
- Gears shift hard or jerky, sometimes or all the time
- Gear changes take too long to complete, sometimes or all the time
- Shifts occur too early, too late or too often, sometimes or all the time
General guidance for car owners. Diagnosis on the car can point to a different cause.