VOLVO
TCM-0A12 - Gear-shift position sensor. Calibration fault
System
Transmission Control Module (TCM)
Volvo models this fault code applies to
Applies to the following models:
8 modelsC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Show models by year and engine (15)
- Volvo C30 (2007–2013)2007–2013Transmission AW55-50/51SN only
- Volvo C70 (2006–2013)2006–2013Transmission AW55-50/51SN only
- Volvo S40 (2004–2013)2004, 2011–2012Transmission AW55-50/51SN only
- Volvo S40 (2004–2013)2005–2010Transmission AW50/51 AWD, AW55-50/51SN only
- Volvo S60 (2001–2009)2006–2007Engine B5254T4, D5244T4, D5244T5 only · Transmission TF-80SC, TF-80SC AWD only
- Volvo S60 (2001–2009)2008–2009Engine D5244T4, D5244T5 only · Transmission TF-80SC only
- Volvo V50 (2004–2013)2004, 2011–2012Transmission AW55-50/51SN only
- Volvo V50 (2004–2013)2005–2010Transmission AW50/51 AWD, AW55-50/51SN only
- Volvo V70 (2000–2008)2006–2007Engine B5254T4, D5244T4, D5244T5 only · Transmission TF-80SC, TF-80SC AWD only
- Volvo V70 (2000–2008)2008Engine D5244T5 only · Transmission TF-80SC only
- Volvo V70 XC / XC70 (2001–2007)2006–2007Engine D5244T4 only · Transmission TF-80SC AWD only
- Volvo XC90 (2003–)2006–2007Engine D5244T4 only · Transmission TF-80SC AWD only
- Volvo XC90 (2003–)2008–2010Engine D5244T4, D5244T5 only · Transmission TF-80SC AWD only
- Volvo XC90 (2003–)2011Engine D5244T18, D5244T4, D5244T5 only · Transmission TF-80SC, TF-80SC AWD only
- Volvo XC90 (2003–)2012All engines except: B5254T2, B6324S5 · All transmissions except: AW50/51 AWD
What does this fault code mean?
The transmission control module sees a faulty reading from the gear position sensor. Although the code is titled as a calibration fault, the condition concerns the signal from the sensor. The fault is caused by the gear selector cable being incorrectly fitted or the gear position sensor not being calibrated.
Possible causes
- Gear selector cable incorrectly fitted
- Gear position sensor not calibrated
What you can do
- 1Have a workshop check that the gear selector cable is correctly fitted and adjusted, then calibrate the gear position sensor
- 2Clear the fault code and move the gear selector through all gear positions to see whether it comes back
- 3If the fault code is still stored, the transmission control module must be replaced by a workshop
Symptoms you may notice1
- General warning lamp lit
General guidance for car owners. Diagnosis on the car can point to a different cause.