VOLVO
TVM-U210000 - Initial Configuration Not Complete. General Failure Information. No sub type information
System
Unknown System / Manufacturer Specific
Volvo models this fault code applies to
Applies to the following models:
9 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
What does this fault code mean?
The television module compares its configuration ID with the vehicle signal configuration that the central electronic module (CEM) sends out on the CAN network. The code is stored when communication with the CEM is lost. The module still answers diagnostic commands, but normal CAN communication does not work.
Possible causes
- The CAN network is interrupted between the infotainment module (ICM) and the central electronic module (CEM)
- The MOST network is interrupted between the infotainment module (ICM) and the TV module (TVM)
- The central electronic module (CEM) is wrongly configured
- The CEM does not send out the vehicle signal configuration over the CAN network
- The ICM does not pass the vehicle signal configuration on to the MOST network
- The TV module does not suit this car, for example a second-hand unit with other software or hardware
What you can do
- 1Read off the codes in the car, clear them and test-drive the TV function to see whether the fault returns.
- 2Check the central electronic module (CEM) first, as it sends the vehicle configuration to the rest of the networks.
- 3Look for loose, corroded or damaged connectors in the connections to the CAN and MOST networks.
- 4If a used TV module has been fitted, check that it is intended for this exact car.
- 5If the fault remains, have a workshop read off and check the configuration in the control modules and load new software where needed.
Symptoms you may notice2
- TV function does not work
- Other problems with the TV function
General guidance for car owners. Diagnosis on the car can point to a different cause.