VOLVO
TVM-U210100 - Control Module Configuration Incompatible. General Failure Information. No sub type information
System
Unknown System / Manufacturer Specific
Volvo models this fault code applies to
Applies to the following models:
9 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
What does this fault code mean?
The TV module uses settings from the vehicle configuration file held in the central electronic module (CEM). The code is set at start-up when the TV module's own local configuration file is missing or incorrect. Faults in communication on the CAN and MOST networks can also lie behind it.
Possible causes
- The CAN network has a break between the infotainment module (ICM) and the CEM
- The MOST network has a break between the ICM and the TV module (TVM)
- The CEM is not configured correctly
- The CEM does not send out the vehicle signal configuration over the CAN network
- The ICM does not pass the vehicle signal configuration on to the MOST network
- The TV module does not suit this car, for example a second-hand unit with other software or hardware
What you can do
- 1Read off the codes, clear them and test-drive the TV function. If the code returns, continue with the next point.
- 2Check that the TV module is the right one for this particular car, especially if it is second-hand.
- 3Check the central electronic module (CEM) first, since it sends out the vehicle configuration.
- 4Look for loose, corroded or damaged connectors on the wiring to the CAN and MOST networks.
- 5If the fault remains, have a workshop read off the codes, load new software into the modules and check the configuration.
Symptoms you may notice2
- TV function does not work
- Other problems with the TV function
General guidance for car owners. Diagnosis on the car can point to a different cause.