P2454 - Particulate Filter Pressure Sensor 'A'' Circuit Low
System
Powertrain (Engine & Gearbox)
Technical Description
The control module has detected a fault in the Particulate Filter Pressure Sensor 'A'' Circuit Low (P2454). The signal is below the lower threshold, typically from a short to ground or an internally shorted sensor.
Multimeter Test Points & Nominal Values
| Test Point / Component | Measurement | Nominal Target Range | Test Condition |
|---|---|---|---|
| Particulate Filter Pressure Sensor 'A'' Circuit Low – Signal Voltage | Voltage (V) | < 0.20 V (fault state) | Ignition ON, connector engaged |
| 5 V Reference Voltage | Voltage (V) | 4.95 - 5.05 V | Ignition ON at sensor connector |
| Sensor Ground Voltage Drop | Voltage (V) | < 0.05 V (< 50 mV) | Under load to chassis ground |
| Signal Wire Continuity | Resistance (Ω) | < 0.5 Ω (Open = OL) | Disconnected harness between sensor and ECM |
Ignition ON, connector engaged
Ignition ON at sensor connector
Under load to chassis ground
Disconnected harness between sensor and ECM
Oscilloscope Waveform Analysis
100 ms/div, 1 V/divPossible Causes
Short to ground on the signal wire or an internal short circuit within Particulate Filter Pressure Sensor 'A'' Circuit Low
Channel A:Verify dedicated wiring pins and signal pair for circuit A against the schematic.
Chafed or pinched wiring harness along the signal path to Particulate Filter Pressure Sensor 'A'' Circuit Low
Poor ground connection or excessive voltage drop (> 0.1 V) at the ground point for Particulate Filter Pressure Sensor 'A'' Circuit Low
Defective internal output driver or reference circuit in the control module for Particulate Filter Pressure Sensor 'A'' Circuit Low
Symptoms
Recommended Solution
Compare signal voltage and resistance between circuit A and companion circuit B at module connector.
Measure signal wire resistance to chassis ground with connector unplugged (must exceed 10 kΩ; low reading confirms short to ground).
Verify loaded supply voltage and harness terminal pins at Particulate Filter Pressure Sensor 'A'' Circuit Low.
Check circuit continuity and ground-side voltage drop (< 0.05 V) for Particulate Filter Pressure Sensor 'A'' Circuit Low.
Unplug the sensor:the signal must swing to a known rail. Replace the sensor or repair the wiring based on the result.
Mechanic's Tip
Always run a loaded voltage-drop test on the sensor ground with ignition ON. A drop above 0.1 V shifts the whole signal and tricks the module into setting sensor codes on a good sensor.
Common Combinations
P2452, P2453, P2454 Skoda Superb 2.0 TDI – Differenstrycksgivare G450 Slanghaveri Technical Diagnostic Guide
SKODA • 76 analyser
P2463, P2458, P2454 VW Golf 2.0 TDI – DPF Askackumulering & Spärrad Regenerering Technical Diagnostic Guide
VOLKSWAGEN • 54 analyser
Related Fault Codes
Exhaust Temperature Too Low For Particulate Filter Regeneration (Bank 2)
Oxygen Sensor (O2) Signals Swapped Bank 2 Sensor '2' / Bank 2 Sensor '3'
Evaporative Emission System (EVAP) Leak Detection Pump Pressure Sensor Range/Performance
Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3')