P2200 - NOx Sensor Circuit (Bank 1 Sensor '1')
System
Powertrain (Engine & Gearbox)
Technical Description
The control module has detected a fault in the NOx Sensor Circuit (Bank 1 Sensor '1') (P2200). Pertains to upstream oxygen sensor (pre-catalyst regulation sensor) governing real-time closed-loop air-fuel ratio.
Multimeter Test Points & Nominal Values
| Test Point / Component | Measurement | Nominal Target Range | Test Condition |
|---|---|---|---|
| NOx Sensor Circuit (Bank 1 Sensor '1') (Upstream Control Sensor) – Heater Resistance (Cold) | Resistance (Ω) | 2.5 - 10.0 Ω | Disconnected plug at 20°C |
| NOx Sensor Circuit (Bank 1 Sensor '1') (Upstream Control Sensor) – Signal Voltage | Voltage (V) | 0.10 - 0.90 V, oscillating 1 - 3 Hz | Warm engine closed loop at 2000 RPM |
| NOx Sensor Circuit (Bank 1 Sensor '1') – Pump Current (Wideband) | Current (mA) | -2.0 to +2.0 mA (0 mA at lambda 1.0) | Warm engine, closed loop |
Disconnected plug at 20°C
Warm engine closed loop at 2000 RPM
Warm engine, closed loop
Oscilloscope Waveform Analysis
1 s/div, 200 mV/divPossible Causes
Bank 1 specific:Inspect wiring harness to cylinder bank 1 (firewall/right bank, exposed to exhaust manifold heat).
Sensor 1 (Upstream pre-cat):Directly exposed to raw exhaust gases. Check for carbon fouling or pre-sensor manifold exhaust leaks.
Chafed or pinched wiring harness along the signal path to NOx Sensor Circuit (Bank 1 Sensor '1')
Poor ground connection or excessive voltage drop (> 0.1 V) at the ground point for NOx Sensor Circuit (Bank 1 Sensor '1')
Defective internal output driver or reference circuit in the control module for NOx Sensor Circuit (Bank 1 Sensor '1')
Symptoms
Recommended Solution
Observe closed-loop sensor voltage switching at 2500 RPM (0.1–0.9 V at 1–3 Hz). Check STFT and LTFT fuel trims.
Cross-swap the component on Bank 1 with Bank 2 to rule out mechanical oil passages and internal timing wear.
Review freeze-frame environmental data and perform fundamental voltage-drop and resistance checks on the circuit.
Verify loaded supply voltage and harness terminal pins at NOx Sensor Circuit (Bank 1 Sensor '1').
Check circuit continuity and ground-side voltage drop (< 0.05 V) for NOx Sensor Circuit (Bank 1 Sensor '1').
For wideband sensors:monitor pump current (mA) and lambda in scan Live Data during snap-throttle and decel fuel cut.
Mechanic's Tip
O2 sensors measure free oxygen, not fuel. An exhaust leak upstream of the sensor pulls in atmospheric air via venturi pulses, forcing false lean readings and causing the ECM to severely over-fuel.