P2681 - Engine Coolant Bypass Valve 'A' Control Circuit/Open
System
Powertrain (Engine & Gearbox)
Technical Description
The control module has detected a fault in the Engine Coolant Bypass Valve 'A' Control Circuit/Open (P2681). The module sees no circuit at all — broken wire, backed-out pin, or a failed sensor.
Multimeter Test Points & Nominal Values
| Test Point / Component | Measurement | Nominal Target Range | Test Condition |
|---|---|---|---|
| Engine Coolant Bypass Valve 'A' Control Circuit/Open – Signal Voltage | Voltage (V) | 0.50 - 4.50 V (tracks operating range) | Ignition ON, connector engaged |
| 5 V Reference Voltage | Voltage (V) | 4.95 - 5.05 V | Ignition ON at sensor connector |
| Sensor Ground Voltage Drop | Voltage (V) | < 0.05 V (< 50 mV) | Under load to chassis ground |
| Signal Wire Continuity | Resistance (Ω) | < 0.5 Ω (Open = OL) | Disconnected harness between sensor and ECM |
Ignition ON, connector engaged
Ignition ON at sensor connector
Under load to chassis ground
Disconnected harness between sensor and ECM
Oscilloscope Waveform Analysis
100 ms/div, 1 V/divPossible Causes
Open circuit, damaged wiring harness, or disconnected plug at Engine Coolant Bypass Valve 'A' Control Circuit/Open
Channel A:Verify dedicated wiring pins and signal pair for circuit A against the schematic.
Chafed or pinched wiring harness along the signal path to Engine Coolant Bypass Valve 'A' Control Circuit/Open
Poor ground connection or excessive voltage drop (> 0.1 V) at the ground point for Engine Coolant Bypass Valve 'A' Control Circuit/Open
Defective internal output driver or reference circuit in the control module for Engine Coolant Bypass Valve 'A' Control Circuit/Open
Symptoms
4
Recommended Solution
Compare signal voltage and resistance between circuit A and companion circuit B at module connector.
Verify continuity (< 0.5 Ω) on the signal wire between the component plug and the ECM header connector.
Verify loaded supply voltage and harness terminal pins at Engine Coolant Bypass Valve 'A' Control Circuit/Open.
Check circuit continuity and ground-side voltage drop (< 0.05 V) for Engine Coolant Bypass Valve 'A' Control Circuit/Open.
Unplug the sensor:the signal must swing to a known rail. Replace the sensor or repair the wiring based on the result.
Mechanic's Tip
Always run a loaded voltage-drop test on the sensor ground with ignition ON. A drop above 0.1 V shifts the whole signal and tricks the module into setting sensor codes on a good sensor.