P0238 - Turbocharger/Supercharger Boost Sensor 'A'' Circuit High
System
Powertrain (Engine & Gearbox)
Technical Description
The control module has detected a fault in the Turbocharger/Supercharger Boost Sensor 'A'' Circuit High (P0238). The signal is above the upper threshold, typically from an open circuit, poor connection, or a short to battery voltage.
Multimeter Test Points & Nominal Values
| Test Point / Component | Measurement | Nominal Target Range | Test Condition |
|---|---|---|---|
| Turbocharger/Supercharger Boost Sensor 'A'' Circuit High – Coil Resistance | Resistance (Ω) | 3 - 30 Ω (typical) | Connector disconnected at 20°C |
| Turbocharger/Supercharger Boost Sensor 'A'' Circuit High – Duty Cycle | PWM (%) | 5 - 95 % (modulates with target) | Engine running, actuator in control |
| Turbocharger/Supercharger Boost Sensor 'A'' Circuit High – Supply Voltage | Voltage (V) | 11.8 - 14.4 V | Ignition ON at connector |
Connector disconnected at 20°C
Engine running, actuator in control
Ignition ON at connector
Oscilloscope Waveform Analysis
2 ms/div, 20 V/divPossible Causes
Open circuit on signal wire, spread terminal pin, or short to power feed at Turbocharger/Supercharger Boost Sensor 'A'' Circuit High
Channel A:Verify dedicated wiring pins and signal pair for circuit A against the schematic.
Chafed or pinched wiring harness along the signal path to Turbocharger/Supercharger Boost Sensor 'A'' Circuit High
Internal mechanical wear or carbon deposits inside Turbocharger/Supercharger Boost Sensor 'A'' Circuit High
Defective internal output driver or reference circuit in the control module for Turbocharger/Supercharger Boost Sensor 'A'' Circuit High
Symptoms
Recommended Solution
Compare signal voltage and resistance between circuit A and companion circuit B at module connector.
Measure signal terminal voltage with ignition ON and sensor unplugged to determine if ECM pull-up is active or harness is shorted to 12V.
Verify loaded supply voltage and harness terminal pins at Turbocharger/Supercharger Boost Sensor 'A'' Circuit High.
Check circuit continuity and ground-side voltage drop (< 0.05 V) for Turbocharger/Supercharger Boost Sensor 'A'' Circuit High.
Check supply and the low-side driver at the ECM connector. Replace the actuator or repair the circuit based on the readings.
Mechanic's Tip
Use the scan-tool output test with the scope on the control side at the same time. If duty changes but the actuator does not move, the valve is stuck — not the electrical fault you were chasing.
Common Combinations
P0106 P0113 P0238 VW Turbo – MAP Sensor G31 & IAT Sensor G42 Diagnostics
VOLKSWAGEN • 208 analyser
P0234 P0236 P0238 VW 2.0 TDI – Turbo Overboost Condition & VNT Vanes Sticking
VOLKSWAGEN • 188 analyser
P0106, P0236, P0238 SEAT Leon 1.4 TSI – MAP-Sensor G71 & G31 Laddtryck Technical Diagnostic Guide
SEAT • 64 analyser